|
***Post a MEME Thread*** | Page 5220 | Yellow Bullet Forums
School lunches were 30 cents. And in the 1st grade, I went to a one room school house in Nebraska. 1st to 8th grade. A wood stove, and an outhouse. There were no school lunches there.
Trans Fluid for powerglide - Yellow Bullet Forums
I am sure this has already been asked a million times, so sorry if I missed it. Can anyone fill me in on what is recommended for the powerglides? Dextron or Type F. I plan on using a synthetic due to its ability to handle the heat better but fill me in on type. Appreciate it very much. Take...
Ford/World products Man-o-War ??? | Yellow Bullet Forums
Search by State: Choose one Outside US/Canada Alabama Alaska Arizona Arkansas California Colorado Connecticut Delaware District of Columbia Florida Georgia Hawaii Idaho Illinois Indiana Iowa Kansas Kentucky Louisiana Maine Maryland Massachusetts Michigan Minnesota Mississippi Missouri Montana Nebraska Nevada New Hampshire New Jersey New Mexico ...
Freight shipping an engine | Yellow Bullet Forums
When Nebraska closed I went direct to HQ in SLC because they called me about the closing. That deal was 2 vidmar cabinets from Brooklyn to Lancaster, the phone guy talked me into using YRC against my better judgement because they were $25 less than the next carrier.
what size winch for an enclosed trailer | Yellow Bullet Forums
The only time I EVER had to use a snatch block on my 2500lb winch to get any vehicle up, I picked up a 57 chevy in Nebraska my grandfather wanted. It was a farm field find, 4 flat tires and car sunk to the frame in the field...and once I got it popped out of the 4 ruts all 4 tires locked up tight too. It single line pulled it just fine upto the trailer ramps, then once it started dragging up ...
Main and Rod bearing prep - Yellow Bullet Forums
Housing bores and the back side of bearing shells can be cleaned with alcohol prior to assembly. ACL bearings are manufactured in Australia. Clevite is still manufactured in Nebraska, USA but that is in the process of being changed, to Mexico in the very near future.
Fuel recommendation for 383 sbc | Yellow Bullet Forums
Just got my 383 build done and in the car. Have not got to test it yet...it currently has ethanol free pump 93 in the tank. Looking to see what it might need for octane. Its a 383 with ported Profiler 72cc aluminum heads, Probe 8cc dome pistons. Cam is a Jones Hyd roller...240-250@.050...
What's a good size winch for car trailer? - Yellow Bullet Forums
Hi, I'm looking to buy a winch for my trailer, my car weighs 3000 pounds. What would be a good size winch to pull the car up onto the trailer? Im using a 2500 now and it struggles. There's a sale on 5000 pound winches and the next size up is 9000. What are you guys using? Thanks!!
cam to rod clearance sbc - Yellow Bullet Forums
i have a dart lil m block 9.025 deck with oliver steel 6 inch rods cam is bullet 900 base with 720 max lift on a 114 lsa, was told to put it in at 110 though i havent checked yet with degree wheel i put it in straight up and it hits on #6 rod if i retard it 2 degrees it is fine what if after...
e85 conversion - Yellow Bullet Forums
Lookin to switch over now. seeing what you guys have been doin as far as switching carb over. you been sendin the carb out or buyin the kit yourself???? i would like to get the kit and do it myself,ive read the quickfuel kit you have to mill on the boosters for them to work,if thats the case i...
|
